Intro:

I thought I could combine beautiful Christmas decorations with a practical Advent wreath. The result: Santa's Advent Wreath. The whole thing includes four 3D printable tealight-candle holders. Printing instructions follow, assembly instructions can be found ont the end. My santa isn't colored because of time problems.(on my pictures, the light on the santa doesn't goes well into the slits. that is fixed in the files)

Printing instruction:

Layer height: 0.2

Support: on the tealight holders with numbers, on the deers, on the santas and on the deerholders  yes, on the rest no (on the print bed only)

Infill: minimum 20%

Printing List:

3x deer

3x flipped deer

4x candle holder

1x sledge outside

1x sledge outside flipped

1x sledge middle

1x all the parts of the deerholder (1-3)

3x deer stabilizer

1x santa

1x santa flipped

1x santa stabalizer

INSTRUCTIONS

first, nimm all the parts of the sledge

then, put them together. if that doesn't work, use a hammer. be gently.Then, glue the three parts of the holder togehther. i addet tape, so i can go further

  then, put the holder on three dears and put the deer-stabilizers into the holes of the deers. be sure to first put the deer-stabilizers into the hodler-holes. here you can also use a hammer. then put the other three dears on the top (here you can also use a hammer). it should look now like this.

then, put the beginning of the deer-holder into the sledge.

then, assembe the santa. for that, put the santa stabilizer in the holes of both santas.now you can put the santa into the holes. be gently, something could break!

now you can put the tealights into the candle-holders and put them on the top of the deers and on the santa . Your'e finished!